Safety Tips
s
s
s
s
s
s
s
s
s
s
Before opening LP cylinder valve, check the coupling nut for
tightness.
When grill is not in use, turn off all control knobs and LP
cylinder valve.
Never move grill while in operation or still hot.
Use long-handled barbecue utensils and oven mitts to avoid
burns and splatters.
Maximum load for sideburner and side shelf is 10 lbs.
Do not use a cooking pot larger than 9” on the sideburner.
A soup can or grease cup be attached to grease
clip/grease tray and emptied after each use. Do not remove
soup can/grease cup until grill has completely cooled.
If you notice grease or other hot material dripping from grill
onto valve, hose or regulator, turn off gas supply at once.
Determine the cause, correct it, then clean and inspect valve,
hose and regulator before continuing. Perform a leak test.
The regulator may make a humming or whistling noise during
operation. This will not affect safety or use of grill.
If you have a grill problem see the .
must
"Troubleshooting Section"
WARNING
• Never attempt to attach this grill to the self-contained LP
gas system of a camper trailer or motor home.
• Do not use grill until leak-tested.
Leak Testing Valves, Hose and Regulator
1. Turn all grill control knob(s) to OFF.
2.
3.
Correct
before proceeding
4.
Be sure regulator is tightly connected to LP cylinder.
Completely open LP cylinder valve by turning hand wheel
counterclockwise. If you hear a , turn gas off
immediately. There is a major leak at the connection.
.
Brush soapy solution onto areas where bubbles are shown
rushing sound
:
Sideburner Hose
(if featured)
s Never remove opening
at end of valve.
Sideburner
Valve
5. If “growing”
If leaks
cannot be stopped “do not try to repair”
6.
bubbles appear, there is a leak. Close LP
cylinder valve immediately and re-tighten connections.
call for
replacement parts. Order new parts by giving the serial
number, model number and name of items needed to the Grill
Service Center at 1-800-241-7548.
Always close LP cylinder valve after performing leak test by
turning hand wheel clockwise.
• If the regulator frosts turn off grill and LP cylinder valve
immediately. This indicates a problem with the cylinder
and it should not be used on any product. Return to
supplier!
WARNING
Valve Check
Hose Check
Turning Grill Off
Ignitor Check
• Important: Make sure gas is OFF at LP cylinder before
checking valves
LOW
•
• Turn gas off at LP cylinder.
. Knobs lock in position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to position then turn back to
position. Valves should turn smoothly.
Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
• Turn all knobs to position. Turn LP cylinder OFF by turning
hand-wheel clockwise to a full stop.
Press ignitor button or turn ignitor
knob rapidly. "Click" should be heard and spark seen each
time between collector box or burner and electrode. See
if no click or spark."Troubleshooting"
OFF
OFF
OFF
Normal
Hose
Kinked
Hose
6
To Next Page
Loading...
