Upper back panel
6
5
1/4-20x1 ½" screw
Knob
Temperature gauge
Temperature gauge stem
Control panel
C
B
Back of the panel
On back of grill, place upper back panel between side panels.
1/4-20x1½” screw on each side.
Secure upper back panel in lower holes, using one
Do not fully tighten screws until side shelf installation is complete in later steps.
A
Insert temperature gauge stem into the bigger hole above knob, shown A. Make sure the gauge is pushed in as
far as it will go, then push the gauge downward until it clips into the panel, as shown in B/C.
16
To Next Page
Loading...
