14
Use two 1/4-in. x 15mm truss head screws (BB) and two 1/4-in. nuts
(EE) to keep the charcoal firebox in place. (Two screw holes are
located in the top of left side charcoal grill firebox panel) as shown
in Fig. 12.
Note: The top 2 screws of the firebox should be screwed from main
firebox inside to charcoal grill firebox. But bottom 2 screws should
be tightened from cart inside to main grill.
Use one 5/32-in. x 10mm truss head screw (AA) and 5/32-in locking
washer (BB) to align the charcoal grill control panel to the main grill
control panel.
Note: Charcoal grill control panel hole is located in the bottom of
the left side of the control panel.
10. Charcoal Big Drawer Handle Assembly
Attach the drawer handle (O) to the big draw front panel (N) using
two 1/4-in. x 12mm truss head screws (JJ) and two 1/4-in. locking
washer (KK) as shown in Fig. 13.
11. Charcoal Tray and Drawers Assembly
Insert the charcoal tray (L) and small drawer (M) and big
draw (N) to the glides accordingly and then push them in as
shown in Fig.14.
Fig. 12
Fig. 14
1 X
2 X
L
B
Fig. 13
Drawer
panel
Drawer
handle
N
To Next Page