How does stand alone mode work on Chauvet Lighting Equipment?
All Chauvet lighting fixtures featuring stand-alone functions do not require additional settings. Simply power the fixture and it will automatically enter into this mode.
What to do if Chauvet Flood Light has no signal output and the signal indicator is flashing?
If your Chauvet Flood Light shows no signal output but the signal indicator is flashing, contact Chauvet Technical Support for assistance.
What to do if my Chauvet Data Stream 4 has no audio reaction?
If your Chauvet DJ Equipment fixture is on but not reacting to the audio, ensure the control switches are set to the correct audio mode. If you're using a ¼” jack for audio, verify that a live audio signal is present. Also, adjust the sound sensitivity knob.
Why do I have loss of signal on my Chauvet Data Stream 4?
To address signal loss in your Chauvet DJ Equipment setup, ensure you are using DMX cables and install a terminator. Keep DMX cables away from power cables and black lights.
What to do if my Chauvet DJ Equipment has no power?
If your Chauvet DJ Equipment device isn't getting power, first, check if the power is on at the mains. Then, inspect the device’s fuse, both internal and external.
What to do if Chauvet Lighting Equipment remote does not work?
If your Chauvet Lighting Equipment remote does not work, make sure the connector is firmly connected to the device.
What to do if there is no laser output on Chauvet Lighting Equipment?
If there is no laser output from your Chauvet Lighting Equipment, the bounce mirror motor may have shifted during shipping. Readjust it.
What to do if Chauvet Lighting Equipment relay will not work?
If your Chauvet Lighting Equipment relay will not work, check the reset switch and cable connections.
What to do if Chauvet Lighting Equipment light will not come on after power failure?
If your Chauvet Lighting Equipment light will not come on after a power failure, some discharge lamps require a cooling off period before the electronics in the fixture can kick start it again. Wait 5 to 10 minutes before powering up.
What to do if Chauvet Lighting Equipment fixture is on but there is no movement to the audio?
If your Chauvet Lighting Equipment fixture is on but there is no movement to the audio, ensure you have the correct audio mode selected on the control switches. If audio is provided via a ¼” jack, make sure a live audio signal exists. You may also need to adjust the sound sensitivity knob.
Lists all components provided with the Data Stream™ 4 fixture.
Guidance on how to unpack the fixture safely and check for damage.
Information on the fixture's auto-switching power supply and voltage requirements.
Crucial safety precautions for installation, operation, and maintenance of the fixture.
Details the key features and capabilities of the Data Stream™ 4.
Provides a visual and descriptive layout of the fixture's components.
Instructions for safely replacing the unit's fuse.
Guidance on connecting multiple fixtures for synchronized operation.
Information on DMX data cables, connectors, and conversion charts.
Instructions for fixture mounting, orientation, and safe rigging practices.
An explanation of DMX-512 protocol and channel addressing.
Contact information for CHAUVET support and general inquiries.
Recommendations for cleaning and maintaining the fixture for optimal performance.
Steps and requirements for returning merchandise for service or repair.
Information on how to report shipping damage or other claims.
Detailed technical data including dimensions, power, and specifications.
Power| AC power | Autoswitching 100V-240V 50/60Hz |
|---|---|
| fuse | 1A 250V |
Operating Environment| maximum ambient temperature | 104°F |
|---|
Weight and Dimensions| length | 19 in |
|---|---|
| width | 5.3 in |
| height | 1.8 in |
| weight | 5.8 lbs |
To Next Page
