Chery QQ3 - Start the Vehicle in Case of Manual Transmission; Driving Start

Start and Operation
36
2. To enter the automatic gearshift
mode, press the AUTO key to
enter the mode, and press the
AUTO key again to enter the
manual gearshift mode;
3. In the case of manual gearshift
mode, push the selector lever
towards the + direction, and
then increase the trans mission
up to adjacent upper gear
position; and push the lever
towards the – direction, and
then reduce the transmission
down to the adjacent lower
gear position；
4. In the case of manual mode,
the upshift can be conducted
under any speed of the vehicle;
and the downshift can be
implemented only when the
speed drop is in allowable
range.
! CAUTION: In the case of emergency
braking, the automatic gear position
drop function can be carried out either
in the AUTO mode or in the MANUAL
mode, without the manual gear drop
operation
Start the vehicle in case of
manual transmission
After the engine starts, shift to the
proper gear position, release the brake,
and slightly step on the accelerator pedal
to make the vehicle gradually enter into
the travel state. If it is difficult to shift the
gear, slowly step on the accelerator pedal,
and shift to the proper gear position
again.
! CAUTION: ： When the vehicle
starts on a slope, the hand brake must be
pulled before the vehicle starts. Slightly
step on the accelerator pedal, release the
hand brake at the same time, and ensure
that the engine bonnet is fully closed,
otherwise, it is difficult to start the
vehicle.

Start the vehicle in case
of AMT transmission
(
)
After the engine starts, shift to the
proper gear position. Regardless of the
AUTO or Manual mode, the vehicle can
start only after manually shifting to the 1
st
gear position. In case of the idle speed,
shift to the 2
nd
gear or below. After
shifting to the proper gear position,
release the brake, step on the accelerator
pedal and then enable the vehicle to enter
the travel state. If the accelerator pedal
isn’t stepped on, although the proper gear
position is shifted, the vehicle can’t travel
yet.
Driving Start
Put into gear after starting the engine and
loose the brake and step down the
accelerate panel slightly to start the car
gradually. If there is any difficulties in