Windshield Wipers
The lever on the right side of the steering column
controls the windshield wipers and washers.
You control the windshield wipers by moving the stalk
up or down.
With variable delay, you can set the wiper speed for a
long or short interval between wipes. This can be
very useful.
Move the stalk
to
INT (Intermittent) then turn the inner
band and choose the delay you want. Turn the inner
band up for longer intervals between wiper cycles. Turn
the band down for shorter intervals.
For steady wiping at low speed, move the stalk down
to
LO.
For higher speed wiping, move the stalk
down further to
HI.
To stop the wiper, move the stalk
up
to
OFF.
Remember that damaged wiper blades may prevent you
from seeing well enough
to
drive safely. To avoid
damage, be sure
to
clear ice and snow from the wiper
blades before using them.
If
they’re frozen
to
the
windshield, carefully loosen or thaw them. If your blades
do become damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers.
A
circuit breaker will stop them until the motor cools. Clear
away snow or ice
to
prevent an overload.
3-7
To Next Page
Loading...
