To
adjust balance or fade
to
the middle position, select
BAL
or FAD. Then press and hold AUDIO for more
than two seconds until you hear a beep. L and a zero
or
F
and a zero will appear on the display.
To adjust both tone controls and both speaker controls
to
the middle position, first end out of audio mode
by pressing another button, causing the radio
to
perform
that function, or by waiting five seconds for the display
to
return
to
time
of
day. Then press and hold AUDIO for
more than two seconds until you hear a beep. CEN
will appear on the display.
Radio Messages
CAL (Calibration): Your audio system has been
calibrated for your vehicle from the factory. If CAL
appears on the display it means that your radio has not
been configured properly for your vehicle and must
be returned
to
the dealership for service.
Playing a Compact
Disc
Insert a disc partway into the
slot,
label side up. The
player will pull it in. The disc should begin playing. The
display will show CD.
If
you want
to
insert a compact
disc with the ignition
off,
first press RCL or the eject
button.
If
an error appears on the display, see “Compact Disc
Messages” later in this section.
1
PREV (Previous): Press this pushbutton
to
go
to
the
previous track
if
the current track has been playing
for less than eight seconds. If pressed when the current
track has been playing for more than eight seconds,
it will go
to
the beginning of the current track. The track
number will appear on the display.
If
you hold the
pushbutton or press it more than once, the player will
continue moving back through the disc.
2
NEXT:
Press this pushbutton to go
to
the next track.
The track number will appear on the display.
If
you
hold the pushbutton or press it more than once,
the player will continue moving forward through the disc.
3-40
To Next Page
Loading...
