3.
4.
Check both sides of the dipstick, and read the lower
level. The fluid level must be in the COLD area for
a cold check or in the HOT area for a hot check.
If
the fluid level
is
in the acceptable range, push the
dipstick back in all the way.
How
to
Add
Fluid
Refer to the Maintenance Schedule to determine what
kind of transmission fluid to use. See
Part
D:
Recommended Fluids and Lubricants
on
page
6-30.
Add fluid only after checking the transmission fluid while
it is hot. (A cold check is used only as a reference.)
If
the fluid level is
low,
add only enough of the proper fluid
to
bring the level up to the
HOT
area for a hot check.
It doesn’t take much fluid, generally less than
0.6
pints
(0.3
L).
Don’t overfill.
Notice:
We recommend you use only fluid labeled
DEXRON@
-111,
because fluid with that label is
made especially for your automatic transmission.
Damage caused by fluid other than DEXRON@
-111
is
not covered by your new vehicle warranty.
After adding fluid, recheck the fluid level as
When the correct fluid level is obtained, push the
described under “How to Check.”
dipstick back in all the way.
5-25
To Next Page
Loading...
