Nhen rotating your tires, always use one of the correct
rotation patterns shown here.
After the tires have been rotated, adjust the front and
rear inflation pressures as shown on the Tire-
Loading Information label. Make certain that all wheei
nuts are properly tightened, See “Wheel Nut Torque”
under
Capacities and Specifications on page
5-92.
r
s-
Rust or dirt on a wheel, or on the parts to
which
it
is fastened, can make wheel
nuts
become loose after a time. The wheel could
come
off
and cause an accident. When you
change a wheel, remove any rust or dirt from
places where the wheel attaches to the vehicle.
In
an emergency, you can use a cloth or a
paper towel to do this;
but
be sure to use a
scraper or wire brush later, if you need to, to
get all the rust or dirt
off.
See “Changing a Flat
Tire” in the Index.
5-6
1
To Next Page
Loading...
