Garage Door Opener Compartment
You can store your garage door opener in the rear
compartment of your overhead console, and operate it
from this position. To install your garage door opener,
follow these instructions:
1. Open the compartment by pressing the latch
forward.
2. Peel the protective backing from the hook and loop
fastener and press it firmly to the back of your
garage door opener.
3. Line up the button of the garage door opener with
one of the four buttons on the compartment door.
Make sure the garage door opener button is
facing down and press the opener firmly into place.
4. Once the opener is installed, use the black pegs
inside the compartment door to make sure the lined
area on the compartment door will contact the control
button on your garage door opener when pressed.
5. Add one peg at a time until your garage door
opener operates with the compartment door
closed when you press on it.
2-49
To Next Page
Loading...
Need help?
General
