Cheyenne HAWK PEN - Equipment transport and storage conditions; Disposal of equipment

32
EN
7.6 Cleaning or replacing O-rings
The large O-ring secures the protective
hose. The small O-ring prevents the handle
from being turned too easily.
If it is too easy to turn the handle,
causing the needle protrusion to alter
accidentally, or if the protective hose is
no longer held in place firmly enough:
! Degrease the O-ring with a soft
cloth dipped in a cleaning agent or
adisinfectant.
! If the problem persists, replace
theO-rings with new ones.
8 Equipment transport and
storage conditions
ATTENTION
Damage to product caused by dropping it
If the HAWK PEN is dropped or falls,
this can damage its motor and the cap
beside the cable connection can come
loose, exposing the cable.
! Always place the HAWK PEN on the
HAWK PEN TRAY so that it cannot roll
away and/or fall.
! If the HAWK PEN does fall or get
dropped, conduct a visual inspection
of the components and a test for
unusual noises.
! Hand over the HAWK PEN to a
specialist retailer for inspection if it
has visible signs of damage, if the
operating noise level changes or if it
stops functioning normally.
! Always transport the HAWK PEN and its
accessories in their original packaging.
! Always store the HAWK PEN and
its accessories under the following
conditions:
Ambient temperature –40 to +50°C
Relative humidity 30 to 75%
Air pressure 200 to 1060hPa
9 Disposal of equipment
! Dispose of the HAWK PEN and
accessories bearing the following
designation in accordance with
the applicable regulations for used
electronic equipment. If necessary,
consult the specialist retailer or the
responsible authorities to learn about
applicable regulations.
! Provide containers at the workplace
for legislation-compliant disposal of
contaminated components.
! Dispose of used or defective safety
cartridges in a sharps container (safety
box) in accordance with the regulations
applicable in your country.
Cheyenne HAWK PEN