To Next PageTo Next Page
Need help?Do you have a question about the Chicago Electric 3733 and is the answer not in the manual?
General| Type | Miter Saw |
|---|---|
| Arbor Size | 5/8 inches |
| Voltage | 120V |
| No Load Speed | 5000 RPM |
| Blade Size | 7-1/4 in. |
Keep work area clean, dry, and free of obstructions. Keep children away.
Store idle equipment in a dry, locked location out of children's reach.
Do not use under influence of alcohol/drugs. Stay alert. Use common sense.
Wear ANSI approved eye and ear protection. Dress safely, avoid loose clothing.
Check for damaged parts, use only identical replacement parts, and maintain with care.
Maintain a safe work environment and proper tile saw location on a sturdy surface.
Ground the product and use only UL approved extension cords with correct gauge.
Keep all safety guards in place and aligned. Allow blade to reach full speed.
Use only specified blades and materials. Do not cut metals or curves. Keep blade wet.
Do not overfill water bath. Avoid splashing water on electrical components.
Keep hands away from blade. Remove tools before starting. Feed workpiece gradually.
Never remove stuck material while running. Do not leave unattended. Never stand on saw.
Be aware of California Prop 65 dust warnings. Pacemaker users consult physician.
Features a built-in water supply for cooling, dust reduction, and easy cleaning.
Detailed steps for removing the old blade and installing a new one safely.
Steps for filling the water bath, adjusting the rip fence, and operating the saw.
Instructions on adjusting the table poles for 22.5 or 45-degree bevel cuts.
Guide for using the angle gauge to position the workpiece for mitered cuts.
Check for loose screws, alignment, damaged parts, and wiring before each use.
Clean with a soft brush, cloth, or vacuum. Use mild detergent if necessary.
Detailed list of all parts with their corresponding part numbers and quantities.
Illustrative diagram showing the assembly of the tile saw components.
