To Next PageTo Next Page
Need help?Do you have a question about the Chicago Electric 60373 and is the answer not in the manual?
General| Type | Angle Grinder |
|---|---|
| Speed | 11, 000 RPM |
| No Load Speed | 11, 000 RPM |
| Wheel Diameter | 4.5 inches |
| Voltage | 120 volts |
| Spindle Thread | 5/8 in.-11 UNC |
| Wheel Arbor Size | 7/8 inch |
Definitions for DANGER, WARNING, CAUTION, and NOTICE CAUTION symbols.
Read all warnings to prevent shock, fire, and injury.
Keep area clean, well-lit, and free of distractions for safe operation.
Proper plug use, avoiding grounded surfaces, and using GFCI in damp locations.
Stay alert, use common sense, dress properly, and maintain balance.
Use safety equipment, prevent unintentional starting, and remove tools.
Do not force the tool, ensure switch works, and disconnect before adjustments.
Maintain tools, keep cutting edges sharp, and store idle tools safely.
Have power tools serviced by a qualified repair person using identical parts.
Follow instructions, use correct accessories, and wear PPE.
Use recommended accessories, check for damage, and ensure proper fit.
Wear PPE, keep bystanders clear, and avoid cord entanglement.
Do not use liquid coolants or unreadable labels; maintain tool.
Consult physician if you have a pacemaker; avoid operating alone.
Be aware of chemicals in dust and cords; take precautions to reduce exposure.
Kickback is a reaction to snagging; prevent with firm grip and proper positioning.
Use recommended wheels/guards, check flanges, and dress appropriately.
Do not jam wheels, avoid positioning body in line with wheel, and support workpieces.
Do not use excessively oversized sanding disc paper.
Be aware of thrown bristles; do not overstress wires.
Take breaks, avoid smoking, wear gloves, and grip lightly.
Check grounding; do not modify plug. Use proper outlets.
Connect three-prong plug to a properly grounded outlet for safety.
Double insulated tools do not require grounding; use standard outlets.
Use heavier gauge cords for longer distances and higher loads.
Key to symbols like Double Insulated, CSA, UL, VAC, Amperes, and warning icons.
Details electrical rating, motor speed, accessory diameter, and spindle thread.
Read the ENTIRE IMPORTANT SAFETY INFORMATION section before setup or use.
Properly install the wheel guard and side handle for safe operation.
Diagram and labels for side handle, switch, wheel guard, and spindle lock.
Turn off tool and unplug before installing accessories.
Inspect wheels, perform ring-test, and mount correctly with gasket.
Use heavy-duty gloves for sharp accessories; ensure correct RPM and size.
Designate a clean, well-lit area; secure workpieces and ensure no hazardous objects nearby.
Grip firmly, start tool at full speed, apply at an angle, and stop tool completely.
Use tool for 15-20 minutes at a time; allow to cool before next use.
Inspect tool for loose screws, damage, or electrical issues before each use.
Wipe surfaces after use; blow dust from vents with compressed air.
Handle accessories carefully; store in a dry area, protected from humidity.
Maintain carbon brushes; replace damaged supply cords by a qualified technician.
Check cord, outlet, thermal reset, and internal damage for starting issues.
Reduce pressure, check extension cord gauge, or have brushes replaced.
Check carbon brushes, internal damage, or blocked vents; use correct extension cords.
Ensure accessory is loose, damaged, or wrong type; check dimension and flange tightness.
Detailed list of all parts with descriptions and quantities for the angle grinder.
Note that parts are for illustration and may not be available individually.
Visual representation of all parts and their assembly sequence.
Details the 90-day warranty, exclusions, and claims process.
