Chicago Electric 90045 User Manual (English)

Other manuals for Chicago Electric 90045

Assembly And Operating Instructions15 pages

Questions and Answers:

J
Jeremy PonceJul 30, 2025
What to do if my Chicago Electric 90045 will not start?
- B
  Brandon HarrisonJul 30, 2025
  If your Chicago Electric Sander won't start, first ensure the cord is properly plugged in. Then, check if the outlet has power. If not, check the circuit breaker, making sure the circuit capacity is adequate and not overloaded. If your tool has a thermal reset breaker, turn it off, let it cool, and press the reset button. If none of these steps work, it may have internal damage or wear, and should be serviced by a qualified technician.
D
David CookAug 4, 2025
Why is my Chicago Electric Sander overheating?
- D
  David PruittAug 5, 2025
  Overheating in your Chicago Electric Sander can occur if you're forcing the tool to work too fast; allow it to work at its own pace. A dull or damaged sanding belt can also cause overheating, so replace it as needed. Blocked motor housing vents can be another reason; wear ANSI-approved safety goggles and a NIOSH-approved dust mask/respirator while blowing dust out of the motor using compressed air. Finally, a long or small diameter extension cord straining the motor can cause overheating. Eliminate the extension cord or use one with the proper diameter for its length and load.
S
Stephen PerezAug 11, 2025
Why is the performance of my Chicago Electric 90045 Sander decreasing?
- U
  uleeAug 11, 2025
  If your Chicago Electric Sander's performance decreases over time, it could be due to a dull or damaged sanding belt, which should be replaced. Another cause could be worn or damaged carbon brushes, which should be replaced by a qualified technician.
C
Caleb WilliamsAug 17, 2025
Why does my Chicago Electric Sander operate slowly?
- B
  Brandi WallaceAug 17, 2025
  If your Chicago Electric Sander operates slowly, the extension cord might be too long or the wire size too small. Try eliminating the extension cord. If you need one, use a shorter, heavier gauge cord.
N
Natalie RodriguezAug 23, 2025
What to do if my Chicago Electric 90045 is making excessive noise?
- D
  devin84Aug 23, 2025
  If your Chicago Electric Sander is making excessive noise or rattling, it could be due to internal damage or wear, such as with the carbon brushes or bearings. In this case, have a technician service the tool.