To Next PageTo Next Page
Need help?Do you have a question about the Chicago Electric 92880 and is the answer not in the manual?
General| No Load Speed | 11, 000 RPM |
|---|---|
| Spindle Lock | Yes |
| Power Source | Corded Electric |
| Disc Diameter | 4-1/2 inches |
| Voltage | 120 Volts |
| Collet Size | Not applicable |
| Weight | 4.4 lbs |
Keep work area clean, well lit, avoid explosive atmospheres, and keep bystanders away.
Match plug to outlet, avoid wet conditions, and do not abuse the cord.
Stay alert, use PPE, prevent unintentional starting, dress properly, and keep footing.
Use correct tool, don't force, maintain tools, keep accessories sharp, and use as instructed.
Recharge correctly, use designated battery packs, keep away from metal, and handle damaged batteries safely.
Have tool serviced by qualified repair person using identical parts.
Get medical check-ups; pregnant or circulation-impaired individuals should not use.
Do not smoke, wear gloves, use lowest vibration tools, and take breaks.
Tools marked Double Insulated do not require grounding and have special double insulation.
Extension cords must not be used with this item's charger.
Charge battery only within 50°-100°F range; use specified charger.
Align ribs/grooves, press pack into place, ensure contacts engage.
Designate clean, well-lit area, free from distractions/hazards; use safety equipment.
Secure work pieces with vise or clamps to prevent movement during operation.
Steps to insert or remove bits using collets and spindle lock.
Steps 2-4 to attach the flexible shaft to the rotary tool.
Pass shaft core through collet nut, depress spindle lock, tighten nut.
Insert bit into collet, then collet into shaft handle, and tighten locking nut.
Swap collars or LED attachment by turning clockwise/counterclockwise.
Charge battery, insert tool, select bit, turn on LED light if desired.
Rotate switch to ON, adjust speed based on material and bit.
Apply bit to material, stop tool by turning switch OFF, unplug.
Inspect before use, wipe after use, clean vents, store in case.
Protect from moisture, damage, and store accessories properly.
Recycle NiCd battery, replace damaged transformer cord by technician.
