SKU 67537 For technical questions, please call 1-800-444-3353. Page 6
Grip the power tool as lightly as pos-6.
sible (while still keeping safe control
To reduce vibration, maintain the 7.
power tool as explained in this manu-
al. If any abnormal vibration occurs,
stop use immediately.
SAVE THESE
INSTRUCTIONS.
GROUNDING
TO PREVENT
ELECTRIC SHOCK
AND DEATH FROM
INCORRECT GROUNDING
WIRE CONNECTION:
Check with a qualied
electrician if you are in doubt
as to whether the outlet is
properly grounded. Do not
modify the Power Cord Plug
provided with the tool. Never
remove the grounding prong
from the Plug. Do not use the
tool if the Power Cord or Plug
is damaged. If damaged, have
it repaired by a service facility
before use. If the Plug will not
t the outlet, have a proper
outlet installed by a qualied
electrician.
Double Insulated Tools: Tools
with Two Prong Plugs
Tools marked “Double Insulated” do 1.
not require grounding. They have
a special double insulation system
and complies with the applicable
-
tories, Inc., the Canadian Standard
Association, and the National Electri-
cal Code.
(See Outlets for 2-Prong Plug.)
Double insulated tools may be used 2.
in either of the 120 volt outlets shown
in the preceding illustration.
(See Outlets for 2-Prong Plug.)
Extension Cords
Grounded tools require a three wire 1.
extension cord. Double Insulated
tools can use either a two or three
wire extension cord.
As the distance from the supply outlet 2.
increases, you must use a heavier
gauge extension cord. Using exten-
sion cords with inadequately sized
wire causes a serious drop in voltage,
resulting in loss of power and pos-
sible tool damage.
(See Table A, next page.)
To Next Page
Loading...