18
1
Position Base in forward facing vehicle
seat with Recline Foot against seat back.
2
Adjust Base Angle by pushing Recline
Buttons while lifting Base. Angle is correct
when Bubble is between arrows.
Vehicle must be on a level surface for the Bubble
to indicate correctly.
3
Route Vehicle Belt through openings
in Base and buckle the vehicle belt.
(Do not put the shoulder belt in locked mode.
See page 15 for more information.)
4
Tighten Vehicle Belt while pushing
Base rmly into vehicle seat.
5
Secure Vehicle Shoulder Belt rmly
under Shoulder Belt Lockoff, while keeping
tension on Belt. Only use the lockoff on the
opposite side of the buckle.
Caution: Do not pull on shoulder belt when
it is in the lockoff.
1
INSTALLATION USING VEHICLE BELT
UAS or Vehicle Belt? This Infant restraint system can be
safely installed using Vehicle Belts or UAS; never use
both. Use the method that results in the MOST SECURE
installation in your vehicle.
2
3
4
5
To Next Page
Loading...
