19
1
2
3
4
6
CHECK Installation:
a
Belts MUST be TIGHT.
b
Base MUST be STABLE.
c
Bubble MUST be between arrows.
d
Belts & Buckles MUST NOT
INTERFERE with attachment of
Carrier to Base.
7
Attach Carrier To Base after properly
securing infant in Carrier.
Uninstalling Base:
Remove Carrier from Base, unbuckle
Vehicle Belt, and remove Base from
vehicle.
NEVER travel with infant restraint system unsecured in vehicle. Passengers
may be injured during a sudden stop or crash.
INSTALLATION USING VEHICLE BELT
5
If using Vehicle Lap Belt only (no
Shoulder Belt), make sure that Lap Belt
is LOCKED, and that free end of Lap
Belt is neatly stored so it DOES NOT
INTERFERE with attachment of Carrier
to Base.
ALWAYS lift up on Carrier to
verify it is properly attached to the
Base.
7
6
ALWAYS place handle in
LOCKED “CARRY” position when
using Infant restraint system in
vehicle.
To Next Page
Loading...
