Chicco KORY Plus i-Size - INSTALLATION; Configuration with the base; Configuration without the base

42
L. Fast-in attachments
M. Stroller release buttons
N. Diagonal belt guide
O. Headrest adjustment buttons
P. Canopy
Base (Fig. 3)
A. Rebound bar
B. Isox connectors
C. Isox attachment indicators:
D. Isox connector buttons
E. Support leg
F. Support leg height adjustment button
G. Leg support correct installation indicator
H. Car seat release levers
I. Car seat fastening slots
J. Indicators conrming proper attachment of car seat to base
K. 360° rotation button
L. Indicator conrming correct position for travel
M. Isox guide
CORRECT POSITION IN THE VEHICLE
40-85 cm
The Kory Plus car seat can be installed in two dierent ways: with the
Full 360 i-Size base and without the Full 360 i-Size base using just
the vehicle's seat belts. The Full 360 i-Size base can be purchased
separately as an accessory.
• Conguration with the base
This is an advanced i-Size child restraint system, type approved pur-
suant to ECE R129 for use on vehicle seats compatible with the i-Size
system in accordance with the indications provided by the vehicle
manufacturer in the instruction manual for the vehicle. If in doubt,
consult either the enhanced child restraint equipment manufacturer
or the retailer.
If the vehicle does not have an i-Size seat check the vehicle compat-
ibility list, available via the QR code on the product installation label
and at the end of this manual.
• Conguration without the base
This is an advanced i-Size child restraint system, type approved pur-
suant to ECE R129 for use on vehicle seats compatible with the i-Size
system in accordance with the indications provided by the vehicle
manufacturer in the instruction manual for the vehicle. If in doubt,
consult either the enhanced child restraint equipment manufacturer
or the retailer.
INSTALLATION
40-85 cm (rear-facing)
Built-in harness sys-
tem + Full 360 i-Size
base with Support
Leg OR Built-in har-
ness system + vehi-
cle seat belts
1. 40-85 cm (Max 13 kg) ”Integral Universal ISOFIX “i-Size””
- installation with Full 360 i-Size base with Support Leg
rear-facing (see illustrations from number 4 to 13B)
The reducer cushion must be used from 40 cm to 60 cm.