44
REAR-FACING INSTALLATION
Locate the LATCH anchor bars in your vehicle. Attach both LATCH
Connectors to the vehicle LATCH anchor bars.
Pull up on the end of the LATCH Adjuster strap (Pull 1
st
) until
strap is tight.
Pull on the
SuperCinch
™
LATCH Tightener strap (Pull 2
nd
) to secure the
Child Restraint.
INSTALL USING LATCH
5
4
6
CHECK YOUR WORK
Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Child Restraint should not move more than 1” (25 mm) from
vehicle seat back or side-to-side.
Make sure Child Restraint is level for REAR-FACING use. Make sure infant’s head
does not fall forward. If necessary, loosen the Latch Strap, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
To Next Page
Loading...
