50
REAR-FACING INSTALLATION
INSTALL USING LAP-SHOULDER BELT
CHECK YOUR WORK
Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Vehicle belt should remain tight and Child Restraint should
not move more than 1” (25 mm) from vehicle seat back or side-to-side.
Make sure Child Restraint is level for REAR-FACING use. Make sure infant’s head
does not fall forward. If necessary, loosen the vehicle belt, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
To Next Page
Loading...
