70
FORWARD-FACING INSTALLATION
Locate Tether anchor in your vehicle. Attach Tether Hook.
Pull Tether Adjuster strap to tighten.
8
INSTALL USING LAP-SHOULDER BELT
CHECK YOUR WORK
Hold Child Restraint at each side near FORWARD-FACING vehicle belt path. Pull
side to side and forward. Vehicle belt should remain tight and Child Restraint
should not move more than 1” (25 mm) from vehicle seat back or side-to-side.
Make sure Bubble is between lines on label for FORWARD-FACING use. If
necessary, loosen the vehicle belt and Tether, re-adjust recline and repeat
installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
To Next Page
Loading...
