What does it mean if the running, defrost, and timer lights are flashing on my Chigo Air Conditioner?
If your Chigo Air Conditioner is under high pressure protection, you'll notice that the running light, defrost light, timer light are flashing.
What does it mean when the defrost, timer, and warning lights are flashing on my Chigo CCA-24HR1 Air Conditioner?
If your Chigo Air Conditioner indicates low pressure protection, the defrost light, timer light, and warning light will flash.
Why is the running, timer, and warning light flashing on my Chigo CCA-24HR1 Air Conditioner?
If the outdoor unit exhaust temperature of your Chigo Air Conditioner is too high, the running light, timer light, and warning light will flash.
Why the ON TIMER indicators go off after a lapse of certain time on Chigo Air Conditioner?
If the ON TIMER indicators go off after a certain time on your Chigo Air Conditioner, it means the timer operation has started. When the set time to start the air conditioner is reached, it will automatically turn on, and the indicator will turn off.
Why does the indication on the display disappears after a lapse of time on Chigo CCA-24HR1 Air Conditioner?
If the indication on the display of your Chigo Air Conditioner disappears after some time, it may be because the timer operation has ended when the OFF TIMER is indicated on the display. The air conditioner stops when the set time has elapsed.
Why TEMP. Indicator does not come on Chigo Air Conditioner?
The temperature indicator on your Chigo Air Conditioner won't appear if the MODE is set to 'FAN ONLY'. You cannot set the temperature during fan-only operation.
What to do if the remote control signal is not transmitted even when the ON/OFF button of Chigo CCA-24HR1 is pushed?
If the remote control signal of your Chigo Air Conditioner is not transmitted even when the ON/OFF button is pushed, it could be due to exhausted batteries in the remote controller. Replace the batteries, as the remote control won't transmit a signal if the power supply is off.
General| Refrigerant | R22 |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Air Flow | 1000 m3/h |
| Type | Split System |
| Operating Temperature | 43 °C |
| Cooling Capacity | 24000 BTU/h |
Explains the coding system for model names of indoor and outdoor units.
Illustrates the electrical connections for various outdoor unit models.
Lists fault codes and their corresponding failure descriptions for outdoor units.
Important safety precautions and procedures for pipe connection.
Procedures for drying refrigerant pipes and checking for leaks.
Guidelines for calculating and adding refrigerant based on pipe length.
Steps and checks required for verifying proper operation after installation.
To Next Page
