Chiltern Invadex Overhead Hoist
8
symptom suggested cause solution
Hoist lacking power Battery power Batteries need
is low charging
Hoist makes beeping Refer to Refer to
sound Appendix A below Appendix A below
Light on hoist No power Ensure that the power is
does not work at switched on at the mains
point of charging
Appendix A Hoist: Audible/ solution
Visual Posts
1. Power up and self 3 Beeps, no repeat Hoist OK. No action
test, hoist reset (light green) required.
2. Weight overload 1 beep + pause, Remove excess weight.
continuous Reset hoist with handset.
(red flashing)
3. Low backup battery 2 beeps + pause, Return to charge position
continuous
(red flashing)
4. Low main 12V Battery 3 beeps+ pause Return to charge position
continuous
(red flashing)
5. Low main 24V battery 4 beeps + pause Return to charge position
continuous
(red flashing)
6. Emergency stop 4 beeps + pause Reset emergency stop
cord pulled continuous and then reset hoist with
(red flashing) handset
Troubleshooting
All models
symptom suggested cause solution
Hoist cuts out whilst Twisted tape or Ensure that tape is not
lifting Maximum load twisted and that the tape is
exceeded vertical. Check weight on
hoist. If hoist is beeping refer
to Appendix A
Lifting tape may Service Engineer required.
be reversed on
the spool.
Hoist lifts when down
button is pressed
To reset the hoist with the handset press and hold the red reset button on the
handset until 3 beeps are heard (see 1 above).
To Next Page
Loading...