What to do if my Chloride UPS displays an OVERLOAD message?
If the Chloride UPS displays an OVERLOAD message, it indicates that there is an overload at the UPS output. To resolve this, reduce the load to a permissible value.
Why does the FAULT indicator illuminate on my Chloride SE041XAT UPS with a continuous alarm?
If the FAULT indicator illuminates and the acoustic alarm is continuously active on your Chloride UPS, this indicates a UPS error or overheating. In case of overheating, decrease the ambient temperature.
How to fix no communication between Chloride SE041XAT and PC?
If there is no communication between your Chloride UPS and PC, first check if you are using the correct serial connection cable, as standard modem/null modem cables are not suitable. Also, verify that the interface on the PC is not being used by another process or is defective; try selecting a different serial interface. Finally, consider that there might be interference on the data cable, so try laying the cable differently or reinstalling the cabling.
What to do if “ON” LED does not illuminate when mains voltage present, acoustic alarm active at intervals in Chloride SE041XAT?
If the “ON” LED does not illuminate when mains voltage is present, and the acoustic alarm is active at intervals on your Chloride UPS, it is likely that the input fuse is defective or the input circuit breaker has tripped. Replace the fuse with one of the same type or switch on the circuit breaker.
What to do if there is no indication and no alarm on my Chloride UPS?
If there is no indication and no alarm, and the Chloride UPS is switched off, it could be due to several reasons: the mains might be switched off (in this case, switch on the main switch), there might be no mains voltage present (have mains inspected by a qualified electrician), or the input fuse might be blown or the input circuit breaker tripped (replace the fuse with one of the same type or switch on the circuit breaker).
Information on how to contact technical services for support.
Provides paramount safety warnings for personnel and operation.
Lists important safety notices for operation and handling.
Safety warnings and precautions related to batteries.
Detailed steps for unpacking the UPS equipment and checking for damage.
Explains the ESD/RPO function for emergency shutdown.
Overview of UPS connection points and procedures.
Detailed instructions for connecting input and output power cables.
Step-by-step guide for connecting external battery cabinets.
Overview of the UPS front panel controls and display.
Lists warning and fault indicators, their causes, and corrective steps.
Step-by-step guide for starting up the UPS unit.
Procedure for safely shutting down the UPS system.
Details the Remote Power Off (RPO)/Emergency Power Off (EPO) function.
Step-by-step guide for setting up a parallel UPS system.
General| Humidity | 0-95% non-condensing |
|---|---|
| Output Voltage | 230 VAC |
| Frequency Range | 50/60 Hz |
| Battery Type | Sealed lead-acid, maintenance-free |
| Operating Temperature | 0-40°C |
| Communication Interface | RS232, USB |
| Protection | Over temperature |
| Storage Temperature | -15-50°C |
To Next Page