Chris-Craft Launch 25 User Manual

Systems
Chris-Craft 3–11
The bilge pump is normally held in place with clips for easy removal and cleaning. Use care when remov-
ing and/or reinstalling the bilge pump. If you remove the pump for cleaning, after reinstalling perform a
systems test to ensure proper operation.
The bilge pump is protected by a circuit breaker located at the Helm Breaker Panel.
Should a bilge pump fail to operate, check the fuse and wiring connections. If the pump operates but fails
to discharge water, inspect for clogs or kinks in the discharge line.
If oil is present in the bilge, do not use the bilge pump to discharge the waste. Mop up the
waste and dispose of properly.
800 GPH Bilge Pump 1000 GPH Bilge Pump
Figure 3-8. Bilge Pumps

Chris-Craft Launch 25 Specifications

General

Beam	8 ft 6 in
Fuel Capacity	75 gal (284 L)
Water Capacity	12 gal (45 L)
Maximum Capacity	10 persons
Hull Material	Fiberglass
Passenger Capacity	10 persons
Engine Options	Single or twin engines