Chris-Craft Launch 22

Questions and Answers

A
Adam LopezAug 8, 2025
What to do if there is no water when faucet is opened on Chris-Craft Boat?
- M
  Monica MooreAug 8, 2025
  If no water comes out when you open the faucet in your Chris-Craft Boat, there might be several reasons: * The pump breaker might be off. If this is the case, switch the breaker to the ON position. * The water tank could be empty. Refill the water tank. * There might be blocked water lines. Find and clear any obstructions. * The pump pressure switch may be defective and require replacement.
T
Tara PenaAug 13, 2025
Why does the fresh water pump cycle on and off in my Chris-Craft Launch 22?
- R
  Raymond BookerAug 13, 2025
  If the fresh water pump cycles on and off in your Chris-Craft Boat, it indicates a leak in the water system. You should find and repair the leak.
N
Nancy Hernandez MDAug 20, 2025
What to do if the pump does not run on Chris-Craft Boat?
- N
  nsimonAug 20, 2025
  If the pump in your Chris-Craft Boat doesn't run, it could be due to several reasons: * The pump breaker might be OFF. Switch the breaker to the ON position. * There may be loose electrical connections. Check the connections and tighten them as needed. * The pump pressure switch could be defective. Replace the switch. * The pump itself might be defective. In this case, refer to your dealer for service.
A
April RichardsAug 26, 2025
How to fix low sea water pressure on Chris-Craft Launch 22?
- H
  hallwarrenAug 26, 2025
  If the sea water pressure is low in your Chris-Craft Boat, it could be due to: * A seacock valve being partially closed. Open the valve fully. * A clogged seacock strainer. Clean the strainer to ensure proper water flow.
A
amarshallSep 1, 2025
Why water sputters from faucet on Chris-Craft Boat?
- O
  odavisSep 1, 2025
  If water sputters from the faucet in your Chris-Craft Boat, it could be due to: * An empty water tank. Fill the water tank. * Air in the system. Open the faucet to exhaust the air, and then close it once a steady stream of water flows.

Summary

Chapter 1: Introduction

General Specifications

Provides detailed specifications for various Chris-Craft boat models including length, beam, weight, and capacities.

Performance

Explains how boat performance is based on selected options and the owner's responsibility for engine knowledge.

Design Category

Details ISO 10240 standard design categories (A, B, C, D) and their application to Chris-Craft boats.

Component Manufacturers

Lists vendors and contact information for major components used in Chris-Craft boat manufacturing.

Chapter 2: Safety and Operations

General Safety Precautions

Offers general safety advice for boat operation, covering mechanical safety, personal limits, and emergency preparedness.

Personal Flotation Devices (PFDs)

Explains federal regulations for PFDs, types, classes, and recommendations for safe usage.

Emergencies

Covers reactions to various emergencies including medical issues, getting help, and specific situations like CO poisoning.

Fire Safety

Details classes of fires, compliant fire extinguishers, and requirements for portable fire extinguishers.

Safety at Sea

Provides guidance on navigating safely, understanding hazards, and procedures for mechanical failures.

Chapter 3: Systems

Switch Identification

Identifies various switches by their icons, aiding in the operation of boat systems.

Fuel Systems

Describes the components of the fuel system and emphasizes safety precautions for handling fuel.

Engines and Controls

Covers engine operation, emergency stop switches, ignition, throttles, and engine instruments.

Electrical System

Details the DC and AC electrical systems, including safety precautions and troubleshooting.

Fresh Water System

Explains the components and operation of the fresh water system, including sanitization and troubleshooting.

Chapter 4: Storage and Commissioning

Winter Storage

Provides a general checklist for preparing the boat and trailer for winter storage.

Spring Commissioning

Outlines general procedures and checks for recommissioning the boat after storage.

Appendix A: Warranty Information

Chris-Craft Limited Warranty

Details the terms, conditions, limitations, and exceptions of the Chris-Craft limited warranty.

Customer Obligations

Outlines the responsibilities of the customer for warranty claims and service.

Arbitration of Disputes

Explains the process for dispute resolution, including waiver of jury trial and arbitration clauses.

Appendix B: Checklists

Safety Boating Checklist

A comprehensive checklist for ensuring boating safety and passenger preparedness.

Pre-Launch Checklist

A checklist to verify boat systems and equipment readiness before launching.

Boat Retrieval Checklist

Steps and checks required for safely retrieving the boat from the water.

Appendix C: Coast Guard Accident Report

Report of Marine Accident, Injury or Death

Contains the official Coast Guard form for reporting marine accidents and injuries.

Appendix D: Float Plan

Float Plan Form

An example form for detailing intended voyage plans for safety and notification purposes.

Appendix E: Trailering

Trailer Selection and Hitch

Guidance on selecting the correct trailer and hitch, including safety chains and brakes.

Launching and Retrieval Procedures

Steps for safely launching and retrieving the boat from a trailer.

Appendix F: Water Skiing

Water Skiing Safety Precautions

Essential safety rules and precautions for water skiing and boat operation.

Understanding Hand Signals

Illustrates common hand signals used for communication between skier and boat driver.

Appendix G: Maintenance Log Forms

Appendix H: Technical Drawings