3–36 Chris-Craft
Systems
Troubleshooting Water Systems
Use the following procedure to help troubleshoot any water problem.
Table 3-2. Water Troubleshooting Chart
Problem Probable Cause
Solution
Sea water pressure low
Seacock valve partially closed Open valve
Seacock strainer clogged Clean strainer
Water sputters from faucet
Water tank empty Fill water tank
Air in system
Open faucet to exhaust air, close
faucet when steady stream of water
flows
Fresh water pump cycles on
and off
Leak in the water system Find and repair leak
No water when faucet is
opened
Pump breaker off Switch breaker to ON
Water tank empty Fill water tank
Blocked water lines Find and clear obstruction
Defective pump pressure switch Replace switch
Pump does not run
Pump breaker OFF Switch breaker to ON
Loose electrical connections Check connections, tighten as needed
Defective pump pressure switch Replace switch
Defective pump Refer to dealer for service
To Next Page
Loading...
Need help?
General
