EasyManua.ls Logo

Chris-Craft Launch 22 - Pre-Launch Checklist

Chris-Craft Launch 22
302 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRE-LAUNCH CHECKLIST
_________ Drain plugs – installed (first visual check)
_________ Boat cover – removed
_________ Wheel chocks – available
_________ Equipment – loaded for proper trim
_________ Bow and stern lines – fastened
_________ Tiedowns – removed
_________ Fuel tanks – full
_________ Outboard or stern drive – tilted up and engine support removed (if applicable)
_________ Check boat systems (engine room blower, bilge pumps, lights, etc.) – operational
_________ Electrical connection to tow vehicle – unplugged
_________ Trailer wheel bearings – cool
_________ Ramp conditions, water depth, current – checked
_________ Drain plugs – installed (second visual check)
LAUNCHING CHECKLIST
_________ Station someone to help direct.
_________ Back straight down the ramp.
_________ Stop with trailer wheels at waters edge.
_________ Secure tow vehicle with parking brake and wheel chocks.
_________ Station helper to hold bow and stern lines from the ramp.
_________ Tighten winch brake and release anti-reverse lock. Do not disconnect winch cable.
_________ If equipped release tilt latch.
_________ Allow boat to slide off trailer.
_________ Unhook winch cable from bow and rewind or secure trailer.
_________ Pull boat to appropriate location and secure.
_________ Return trailer tilt to horizontal and lock.
_________ Remove chocks and drive tow vehicle and trailer from ramp.

Table of Contents

Related product manuals