Need help?Do you have a question about the Christie D4K Series and is the answer not in the manual?
General| Resolution | 4096 x 2160 (4K) |
|---|---|
| Contrast Ratio | 2000:1 |
| Projection Technology | DLP |
| Light Source | Xenon lamp |
| 3D Capability | Yes |
| Input | HDMI, DVI, 3G-SDI |
| Lens Options | Multiple interchangeable lenses |
| Lamp Life | 1, 500 hours |
Troubleshoot missing image quadrants with Twin DisplayPort Input cards (TDPIC) and AMD FirePro graphics.
Diagnose projector failure to lock onto non-master video signals in Four Port Input configurations.
Resolve reversed colors (e.g., blue/green swap) and Formatter Mismatch alarms.
Address Formatter Mismatch errors when colors are correct, often due to temperature harness issues.
Configure projector settings to prevent restarting DisplayPort sources after power cycling.
Troubleshoot 'Bad Power' status on Environmental Board, often due to harness connection issues.
Resolve green vertical bars in image from incorrect signal detection or sync issues.
Diagnose and fix intermittent or inoperative video with the 3G/HD/SD-SDI input card.
Address issue where lamp hours are not reset to zero for a new projector.
Resolve projector boot-up issues and unresponsiveness caused by v1.2.0 software defects.
Synchronize Shutter SW and HW statuses for correct projector shutter status reporting.
Troubleshoot lamp shutdown and cool-down mode after Shutter Close command.
Resolve 'Fault Detected' alarms on Lamp Power Supply, often due to AC relay disconnection.
Address 'Flow Impeded' alarms in liquid cooling, checking flow and temperature.
Fix image issues like color separation, convergence, or banding with memory controller updates.
To Next Page
