Need help?Do you have a question about the Christie Roadster HD14K-M and is the answer not in the manual?
General| Brightness | 14, 000 lumens |
|---|---|
| Resolution | 1920 x 1080 |
| Contrast Ratio | 2000:1 |
| Technology | DLP |
| Lamp Type | Xenon |
| Projection Lens | Optional lenses available |
| Input Connectors | HDMI, DVI, VGA, Composite, Component |
| Lamp Life | 2, 000 hours |
Safety precautions for servicing energized Christie equipment.
Essential safety precautions to prevent injury and equipment damage.
Warnings about potential death or serious injury if safety is not observed.
Warnings and precautions related to AC power supply and connectors.
Safety warnings and procedures for handling projector lamps.
Importance of maintaining component cleanliness for optimal performance.
Specific instructions for cleaning various projector components.
Safety and warning guidelines for power cords and attachments.
Procedures for cleaning optical surfaces without touching the lens.
Steps to clean dust from the projector lens.
Steps to clean fingerprints, smudges, or oil from the projector lens.
Procedure to adjust lens mount tilt for screen-to-projector alignment.
Procedure for aligning red, green, and blue color overlaps for image clarity.
General guidelines to follow before performing troubleshooting procedures.
Steps to retrieve diagnostic error logs from the projector via web browser.
Instructions for sending projector error logs to Christie technical support.
Information on how to retrieve detailed LCD error messages.
A list of projector LCD error messages and their conditions/solutions.
Detailed troubleshooting flowchart for Critical Hardware Faults.
General tasks to perform before servicing or replacing projector parts.
Step-by-step instructions for removing the projector's top cover.
Procedure to remove the projector's rear panel.
Steps to remove the projector's lamp side panel assembly.
Instructions for removing the projector's intake side panel.
Steps to remove the projector's front cover for access.
Procedure to replace the projector's dust air filter.
Procedure to replace the projector's fog oil filter.
Steps to remove the electronics intake fan #2 from the projector.
Procedure to remove the electronics intake fan #7 from the projector.
Procedure to remove the projector lamps.
Steps to install new projector lamps.
To Next Page