Boresight Alignment Procedure Instruction Sheet 1 of 3
020-100116-01 Rev. 1 (11/07)
Boresight Alignment Procedure
Instruction Sheet
INTRODUCTION
The following instructions outline Boresight Adjustment on any Roadster, Mirage, Matrix, DLV,
Christie DS and Christie DW model projector.
Boresight alignment ensures the projection lens is precisely parallel with the exit-face of the prism and
that the correct distance exists between the exit face and the input of the projection lens. Typically, this
procedure is performed whenever a lens mount is replaced to ensure the displayed image has optimum
focus in all four corners and the center.
NOTICE: Projectors must be serviced in a clean environment to prevent dust particles from settling on
optical components.
TOOLS REQUIRED
Lens cap with pinhole in center (Recommended, but not necessary).
WARNINGS
Replacement must be performed by qualified Christie service personnel only.
Observe all electrostatic precautions.
To Next Page
Need help?
General
