CONTENTS
MOUNTING REQUIREMENTS ........................... 1
OUTLINE AND CUT OUT DIMENSIONS ........... 2
CONNECTION DIAGRAMS ................................ 3
PRELIMINARY HARDWARE SETTINGS ........... 9
CONFIGURATION PROCEDURE .................... 10
OPERATIVE MODE .......................................... 18
Display function .......................................... 18
Indicators ................................................... 18
Pushbutton function during
operating mode .......................................... 19
Enable/disable the control output ............... 20
SP/SP2 selection ....................................... 20
OUT 1 failure detection function ................. 20
Direct access to the set point ..................... 20
Manual function .......................................... 21
Serial link ................................................... 21
Lamp test ................................................... 22
SMART function ......................................... 22
OPERATIVE PARAMETERS ............................ 23
ERROR MESSAGES ........................................ 26
GENERAL INFORMATIONS ............................ 28
MAINTENANCE ................................................ 32
DEFAULT PARAMETERS ............................... A.1
II
1604-0-BC.p65 5/16/00, 10:25 AM2
To Next Page
Loading...
