TEST 8A
REPAIRING PRND3L INDICATOR MALFUNCTIONS
Perform TEST 1A Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
NOTE: USING THE DRB,
VERIFY
START TEST 8A. COMMUNICATIONS WITH
THE MIC BEFORE
PERFORMING TEST .
WHILE OBSERVING NOTE: THIS SHOULD REPLACE AND
THE PRND3L LAMPS, TURN ON ALL PRND3L DID ALL PRND3L NO RECALIBRATE THE
CYCLE THE IGNITION INDICATORS AT THE INDICATORS INSTRUMENT CLUSTER
FROM OFF TO RUN. SAME TIME. ILLUMINATE? CIRCUIT BOARD.*
YES
WITH THE DRB, WITH THE DRB,
SELECT SELECT "MONITOR
TRANSMISSION DISPLAY" THEN
CONTROL MODULE. "SHIFT LEVER".
NOTE: ENGAGE THE
MONITOR THE "SLP" PARKING BRAKE AT
STATE OF THE SHIFT THIS TIME BEFORE
LEVER STATUS. PROCEEDING.
DOES THE SLP
MOVE THE GEAR SHIFT READING MATCH THE YES REPLACE THE
LEVER THROUGH ALL STATE OF THE INSTRUMENT
DIFFERENT POSITIONS. TRANSMISSION GEAR? CLUSTER.*
NO
NOTE: IF ALL PRND3L REFER TO THE
INDICATORS ARE APPROPRIATE
ILLUMINATED, VERIFY THAT 42LE TRANSAXLE
THE CORRECT TCM IS DIAGNOSTIC
INSTALLED. MANUAL.
I
N
S
T
R
U
M
E
N
T
C
L
U
S
T
E
R
317
To Next Page
Loading...
