Chrysler 300M 1999 - Repairing Dr Door Central Lock (Arm);Unlock (Disarm) Switch Failure Trouble Code

TEST 13A
REPAIRING (DR DOOR CENTRAL LOCK (ARM)/UNLOCK (DISARM) SWITCH
FAILURE( TROUBLE CODE
Perform TEST 1A Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TURN THE IGNITION
ON. USING THE DRB,
START TEST 13A. ERASE THE TROUBLE
CODE.
USING THE DRB ENTER INSERT THE LEFT REPAIR OR REPLACE
"BODY COMPUTER" THEN DOOR KEY AND DOES THE SWITCH YES THE LEFT DOOR LOCK
"SENSORS" AND SLOWLY ROTATE THE BIND IN ANY OR KEY CYLINDER
OBSERVE LT DOOR SWITCH FROM LOCK POSITION? SWITCH AS
ARM/DISARM SW. TO UNLOCK. NECESSARY.*
NO
CONTINUE SLOWLY DOES THE VOLTAGE
TURNING THE SWITCH CHANGE FROM 0.0 TO YES SWITCH IS
AND OBSERVE THE ABOVE 3.0 VOLTS AND OPERATING PROPERLY
VOLTAGE ON THE RETURN TO 0.0 IN AT THIS TIME.
DRB. NEUTRAL POSITION?
NO
REMOVE LEFT FRONT USING THE DRB,
DOOR TRIM PANEL. READ THE "LT DOOR IS ANY VOLTAGE NO REPLACE THE DOOR
DISCONNECT THE DOOR ARM/DISARM SW" PRESENT? KEY CYLINDER
KEY CYL SW HARNESS VOLTAGE. SWITCH.*
CONN.** FIG. 1
YES
DISCONNECT THE BODY USING A VOLTMETER, REPAIR THE LEFT
CONTROL MODULE C4 MEASURE THE LEFT IS THE VOLTAGE YES VTSS ARM/DISARM
HARNESS CONNECTOR.** VTSS ARM/DISARM ABOVE 0.1 VOLTS? SENSE CIRCUIT FOR
SENSE CIRCUIT. A SHORT TO
SEE GENERAL INFO 4.0 FIG. 1 VOLTAGE.*
NO
REPLACE THE BODY
CONTROL MODULE.*
P
O
W
E
R
D
O
O
R
L
O
C
K
S
Y
S
T
E
M
609