TEST 45A
REPAIRING RIGHT MIRROR INOPERATIVE FROM MEMORY
Perform TEST 1A Before Proceeding
*Perform Verification TEST VER-4A. **Check connectors - Clean / repair as necessary.
NOTE: FOR LOCATION NOTE: IF THE SEAT
OF ALL COMPONENTS IS UNBOLTED FOR THE SEAT FRAME TO
START TEST 45A. TESTING, CONNECT A A KNOWN GOOD
JUMPER WIRE GROUND.
SEE GENERAL INFO 4.0 FROM...
USING A VOLTMETER,
DISCONNECT THE MEASURE THE RIGHT
MHSMM "C2" HARNESS MIRROR LEFT DRIVER
CONNECTOR.** CKT (CAVITY 12).
FIG. 1
PRESS THE RIGHT DID THE VOLTAGE
MIRROR SWITCH TO READ ABOVE 10.0 NO REPAIR THE OPEN
THE LEFT POSITION VOLTS WHEN THE RIGHT MIRROR LEFT
AND OBSERVE THE SWITCH WAS DRIVER CIRCUIT.*
VOLTMETER. PRESSED?
YES
USING A VOLTMETER, PRESS THE RIGHT DID THE VOLTAGE
MEASURE THE RIGHT MIRROR SWITCH TO READ ABOVE 10.0 NO REPAIR THE OPEN
MIRROR UP DRIVER THE UP POSITION VOLTS WHEN THE RIGHT MIRROR UP
CKT (CAVITY 13). AND OBSERVE THE SWITCH WAS DRIVER CIRCUIT.*
FIG. 1 VOLTMETER. PRESSED?
YES
USING A VOLTMETER, PRESS THE RIGHT DID THE VOLTAGE REPAIR THE OPEN
MEASURE THE RIGHT MIRROR SWITCH TO READ ABOVE 10.0 NO RIGHT MIRROR
MIRROR COMMON DRIVER THE DOWN POSITION VOLTS WHEN THE COMMON DRIVER
CKT (CAVITY 11). AND OBSERVE THE SWITCH WAS CIRCUIT.*
FIG. 1 VOLTMETER. PRESSED?
YES
REPLACE THE MEMORY
HEATED SEAT MIRROR
MODULE (MHSMM).*
M
E
M
O
R
Y
S
Y
S
T
E
M
543
To Next Page
Loading...
