TEST 9A
REPAIRING NO CLUSTER MESSAGES
Perform TEST 1A Before Proceeding
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
WITH THE DRB DOES THE DRB PERFORM
SELECT DISPLAY YES "VECHICLE
START TEST 9A. "NO RESPONSE" FROM COMMUNICATION"
"ELECRO/MECH THE MIC? TEST 1A.
CLUSTER (MIC)".
NO
WITH THE DRB SELECT "WARNING LAMP DOES THE WARNING
"PASSIVE STATUS" TO READ LAMP STATUS NO PERFORM TEST
RESTRAINTS", THE LAMP MESSAGES MESSAGES DISPLAY 19A.
"AIRBAG", "MONITORS" FROM THE CLUSTER. "NO RESP"?
AND...
YES
WARNING: DISCONNECT THE DISCONNECT THE
DISCONNECT THE AIRBAG CONTROL INSTRUMENT CLUSTER
BATTERY AND WAIT 2 MODULE 23-WAY C1 HARNESS
MINUTES BEFORE HARNESS CONNECTOR.** CONNECTOR.**
PROCEEDING. FIG. 1
USING AN OHMMETER, MIC HARNESS
MEASURE THE PCI CONNECTOR C1 TO IS THE RESISTANCE YES REPLACE THE
BUS CIRCUIT THE ACM 23-WAY BELOW 5.0 OHMS? INSTRUMENT
FROM THE ... HARNESS CONNECTOR. CLUSTER.*
FIGS. 2 AND 3
NO
REPAIR THE OPEN
PCI BUS CIRCUIT.*
A
I
R
B
A
G
S
Y
S
T
E
M
73
To Next Page
Loading...
