TEST 13A
REPAIRING PASSENGER SQUIB CIRCUIT SHORTED
Perform TEST 1A Before Proceeding
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
NOTE: FOR LOCATION WARNING:
OF ALL COMPONENTS. DISCONNECT THE
START TEST 13A. BATTERY AND WAIT 2
MINUTES BERFORE
SEE GENERAL INFO 4.0 PROCEEDING.
ENSURE THE IS COMPLETELY
PASSENGER AIRBAG CONNECTED BEFORE WAS THE CONNECTOR NO CONNECT THE AIRBAG
MODULE SQUIB DISCONNECTING IN COMPLETELY MODULE.*
HARNESS NEXT STEP. CONNECTED?
CONNECTOR...
YES
DISCONNECT THE USING AN OHMMETER,
PASSENGER AIRBAG MEASURE BETWEEN THE IS THE RESISTANCE NO REPLACE THE
MODULE SQUIB PASSENGER AIRBAG BELOW 5.0 OHMS? PASSENGER AIRBAG
HARNESS LINE 1 AND LINE 2 MODULE.*
CONNECTOR.** CKTS. FIG. 1
YES
DISCONNECT THE ACM REPAIR PASSENGER
23-WAY HARNESS AIRBAG WIRING IS THE WIRING YES AIRBAG LINE 1
CONNECTOR AND HARNESS FOR DAMAGED? CIRCUIT FOR A
INSPECT THE DAMAGE. SHORT TO LINE 2
PASSENGER... CIRCUIT.*
NO
PERFORM TEST
19A.
A
I
R
B
A
G
S
Y
S
T
E
M
81
To Next Page
Loading...
