22 GETTING TO KNOW YOUR VEHICLE
(Continued)
The ignition can be placed in the following
positions:
OFF
The vehicle is stopped
Some electrical devices (e.g. central locking,
alarm, etc.) are still available
ACC
Some electrical devices are available (e.g.
power windows)
Mechanical power (Vehicle Propulsion) is not
available
ON/RUN
Driving position
All the electrical devices are available (e.g.
climate controls, etc.)
As long as the READY appears in the instru-
ment cluster display, it does not matter if the
engine is running or not, vehicle propulsion is
available
NOTE:
Vehicle propulsion is only available after the
vehicle has passed through the START position.
Conditions Causing Engine To Run
While maintaining the Hybrid Battery State of
Charge (SOC)
When applying maximum vehicle accelera-
tion
When maximum passenger compartment
heating has been turned on
While maintaining the Exhaust System Cata-
lyst Temperature (after engine start in
current ignition cycle - emissions require-
ment)
When the engine is temporarily operating in
Fuel and Oil Refresh Mode
When the hood is open with the ignition in
RUN, post-START mode (eliminates unex-
pected engine start-ups)
In case the ignition switch does not change with
the push of the button, the key fob may have a
low or depleted battery. In this situation, a back
up method can be used to operate the ignition
switch. Put the nose side (side opposite of the
emergency key) of the key fob against the
START/STOP ignition button and push to
operate the ignition switch.
Keyless Push Button Ignition
WARNING!
When leaving the vehicle, always remove
the key fob from the vehicle and lock your
vehicle.
Never leave children alone in a vehicle, or
with access to an unlocked vehicle.
Allowing children to be in a vehicle unat-
tended is dangerous for a number of
reasons. A child or others could be seriously
or fatally injured. Children should be
warned not to touch the parking brake,
brake pedal or the gear selector.
21_RU2_H_SU_EN_USC_t.book Page 22
To Next Page
Loading...
