38 GETTING TO KNOW YOUR INSTRUMENT PANEL
INSTRUMENT CLUSTER DISPLAY MENU
I
TEMS
NOTE:
The Instrument Cluster Display menu items
display in the center of the instrument cluster.
Menu items may vary depending on your vehicle
features.
Speedometer
Push and release the up or down arrow
button until Speedometer is highlighted in the
instrument cluster display. Push and release
the OK button to toggle between mph and
km/h.
Vehicle Info
Push and release the up or down arrow
button until Vehicle Info is highlighted in the
instrument cluster display. Push the left or
right arrow button to scroll through the
following information submenus:
Tire Pressure
If tire pressure is OK for all tires, a vehicle
ICON is displayed with tire pressure values in
each corner of the ICON.
If one or more tires have low pressure,
“Inflate Tire To XX” is displayed with the
vehicle ICON, and the tire pressure values in
each corner of the ICON with the pressure
value of the low tire displayed in a different
color than the other tire pressure value.
If the Tire Pressure system requires service,
“Service Tire Pressure System” is displayed.
Tire Pressure is an information only function
and cannot be reset.
Coolant Temperature
Displays the actual coolant temperature.
Oil Temperature
Displays the actual oil temperature.
Oil Pressure
Displays the actual oil pressure.
Battery Voltage
Displays the actual Low Voltage Battery
System’s Voltage.
Engine Hours — If Equipped
Displays the number of hours of engine oper-
ation.
Oil Life
Displays the remaining engine oil life as a
percentage.
To reset the Oil Life, you must hold the OK
button. The “Hold OK to Reset” instruction
will be displayed at all times, but the
following conditions will need to be met in
order to reset Oil Life:
The vehicle propulsion system must be
OFF
The ignition must be in the ON/RUN posi-
tion
If the conditions are met, holding the OK
button will reset the gauge and the numeric
display will return to 100%.
If the conditions are not met, a pop-up
message will display for five seconds,
describing the required conditions, and then
the Oil Life screen will reappear.
NOTE:
This procedure should only be performed after
scheduled maintenance is completed. Reset-
ting oil life other than when associated with a
21_RU2_H_SU_EN_USC_t.book Page 38
To Next Page
Loading...
