50 STARTING AND OPERATING
Achieving Propulsion System Active (PSA) Using
ENGINE START/STOP Button
1. The transmission must be in PARK or
NEUTRAL.
2. Press and hold the brake pedal while
pushing the ENGINE START/STOP button
once.
To release the parking brake manually, the
ignition switch must be in the ON/RUN position.
Press on the brake pedal, then push the parking
brake switch momentarily.
If the driver shifts into PARK while moving, the
vehicle may park.
Park will engage ONLY when vehicle speed is
1.2 mph (1.9 km/h) or less.
The message “Vehicle Speed is Too High to
Shift to P” will display in the instrument cluster
display if vehicle speed is above 1.2 mph
(1.9 km/h). The gear position indicator will blink
continuously until the selector is returned to the
proper position, or the requested shift can be
completed.
AFTER STARTING
To optimize energy efficiency, the vehicle will
automatically control engine operation.
TO TURN OFF THE VEHICLE USING
ENGINE START/STOP B
UTTON
1. Place the gear selector in PARK, then push
and release the ENGINE START/STOP
button.
2. The ignition button indicator will return to
the OFF position.
3. If the gear selector is not in PARK, with
vehicle speed less than 5 mph (8 km/h),
when the ENGINE START/STOP button is
pushed, the instrument cluster display will
display a “Vehicle Not In Park” message,
and the vehicle will remain running.
4. If the gear selector is not in PARK, with
vehicle speed greater than 5 mph (8 km/h),
when the ENGINE START/STOP button is
pushed continuously for at least two
seconds (or three short pushes in a row) the
vehicle ignition mode will exit Drive “Ready”
mode and enter “Accessory mode”. Never
leave a vehicle out of the PARK position, or
it could roll.
NOTE:
This vehicle is equipped with an automatic
shutdown feature. If the vehicle is left in a
“READY” state (vehicle running) with the gear
selector in “PARK” for one hour, the vehicle
will automatically turn itself off.
The vehicle provides automatic notification,
using a three Horn Chirp Alert, cluster
chiming, and a cluster message (“Key Fob
has Left the Vehicle”) if the vehicle was not
turned OFF (still “Ready to Drive”) and a valid
key fob for the vehicle is not detected within
the passenger cabin, following the opening
and closing of any passenger compartment
WARNING!
If vehicle speed is not below 1.2 mph
(1.9 km/h) when the driver shifts into PARK,
the transmission will default to NEUTRAL until
the vehicle speed drops below 1.2 mph
(1.9 km/h) and the above condition are met,
enabling AutoPark. A vehicle left in the
NEUTRAL position can roll. As an added
precaution, always apply the parking brake
when exiting the vehicle.
21_RU2_H_SU_EN_USC_t.book Page 50
To Next Page
Loading...
