500-9030v3.3 (August 2001) © 2001 CSG Security Inc. / Sécurité CSG Inc.
iii
Industry Canada Notice of Limitations
Notice:
The Industry Canada Label identifies
certified equipment. This certification means
that the equipment meets telecommunications
network protective, operational and safety
requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements
documents(s). The Department does not
guarantee the equipment will operate to the
user's satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be
installed using an acceptable method of
connection. The customer should be aware
that compliance with the above conditions may
not prevent degradation of service in some
situations.
Repairs to certified equipment should be
coordinated by a representative designated by
the supplier. Any repairs or alterations made
by the user to this equipment, or equipment
malfunctions, may give the
telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together. The precaution may be
particularly important in rural areas.
Caution:
Users should not attempt to make
such connections themselves, but should
contact the appropriate electric inspection
authority, or electrician, as appropriate.
Ringer Equivalence Number (REN): The REN
assigned to each terminal device provides an
indication of the maximum number of terminals
allowed to be connected to a telephone
interface. The termination on an interface may
consist of any combination of devices subject
only to the requirement that the sum of the
Ringer Equivalence Numbers of all the devices
does not exceed 5.
The REN for the MONITOR AFx is: 0.1
To Next Page
Need help?
General
