29
8. EXTRAORDINARY MAINTENANCE
• DISPLAYING THE TEMPERATURE
The display of the temperature of the reserve compartment is entrusted to the digital thermometer located on the
controls panel.
The thermometer is powered by a battery which will have to be replaced when needed.
Given the high relevance of the temperature indication, it is important that the battery is replaced as soon as a decrease
in the distinctness of the indicated gures is noted.
• DEFROSTING
The defrosting of the reserve cell can only be carried out manually by removing the electric power supply
through main switch (6).
6.6. Loading the product
• Before inserting the product to be refrigerated into the appliance, wait for it to have reached the temperature
set on the control unit and the compressor has started to cycle.
• This appliance cannot be used as temperature blast-chiller but only as display, therefore, when inserting, the
product must already be at preservation temperature.
• Arrange the product so as not to exceed the provided load limit (see drawings page
17).
• It is recommended to rotate the products, rstly using those which have been in the
display cabinet longer.
!
WARNING
IT IS IMPORTANT NOT TO EXCEED THE PROVIDED LOAD LIMIT (SEE PAGE 17) IN ORDER NOT
TO ALTER THE CORRECT AIR CIRCULATION AND AVOID A HIGHER PRODUCT TEMPERATURE AND
POSSIBLE RISK OF ICE BLOCKS FORMING ON THE EVAPORATOR
!
WARNING
CERTAIN CONFECTIONERY PRODUCTS, ESPECIALLY THOSE GARNISHED WITH CREAM OR CUSTARD,
ARE SUBJECT, WITH THE PASSING OF TIME, TO DETERIORATION. REMEMBER THAT THE DISPLAY
CABINET IS A SELLING DISPLAY AND NOT FOR PRESERVATION!
6.7. Use of sliding
In order to guarantee the correct use of the display cabinet, the shutter, or the sliding, must always be placed in
closing position every time the selling activity allows it.
6.8. Stopping the appliance
For the permanent stopping of the appliance, it is necessary to act only on the main switches or the power supply
plug to remove the current to the display cabinet and condensing unit.
( g.8).
To Next Page