Cincinnati 175 CB - Electrical Connections_3

..... --------CAUTION -------- ...
STANDARD PRESS BRAKES ARE DESIGNED
FOR AND SHIPPED WITH PETROLEUM BASED
HYDRAULIC FLUIDS, WHICH
ARE FLAMMABLE.
CHECK APPLICABLE FIRE CODES FOR SPECIAL
PRECAUTIONS.
ELECTRICAL CONNECTIONS
As shown on the Foundation Plan drawing, suitable leads
must be brought to the machine into the electrical control
panel on the right housing. This is the only electrical
connection that is necessary. Be certain that proper
voltage is fed to the press brake, that the lines are of
sufficient capacity and· that a suitable ground conductor is
attached.
3
NOTE: CINCINNATI INCORPORATED CB Hydraulic Press
Brakes are factory wired for 460V/3/60HZ service.
If service is other than this, do not remove
warning tag from the main disconnect or connect
any power to the machine until a CINCINNATI
INCORPORATED
Service Representative inspects
and services the machine.
Do not start the main drive motor until thoroughly
reading the OPERATION section of this manual and
a CINCINNATI INCORPORATED Service Represent-
ative is present.