Why is the System Error LED blinking on my CircuPool Core?
If the System Error LED is blinking on your CircuPool Water Filtration System, it may be due to debris stuck in the electrical connection between the cell and control module. Remove the control module from the cell and clean it. If the issue persists, there may be another communication problem between the cell and control module; in this case, contact Customer Support.
What to do if the System Error LED is on in CircuPool Water Filtration Systems?
If the System Error LED is on in your CircuPool Water Filtration System, it could be due to debris stuck in the electrical connection between the cell and control module. Remove the control module from the cell and clean it. Also, inspect the cell blades for debris or scaling and clean if necessary. If the issue continues, a more serious error may have occurred, and you should contact Customer Support.
Why are all the LED lights flashing on my CircuPool Water Filtration Systems?
If all the LED lights are flashing on your CircuPool Water Filtration System, the salt level may be greatly out of range. Manually verify the salinity.
Guidelines for achieving optimal salt concentration for the pool.
Step-by-step instructions for removing mineral buildup from the cell.
Instructions for integrating the unit into the pool's plumbing system.
Electrical connection guidelines for safe and proper operation.
A comprehensive list of steps to verify before operating the system.
Addresses issues like low chlorine, no power, and LED indicators.
General| Cell Material | Titanium |
|---|---|
| Warranty | 3 years |
| Type | Saltwater Chlorine Generator |
| Flow Rate | 20 GPM |
| Model | Core Series |
| Voltage | 120/240 VAC |
To Next Page
