With the Auto Repeat function enabled, the instrument will make further 15 minute
measurements, one after the next until the total number of measurements has been
made. This allows the user to tell the instrument, for example, to make 96 individual 15
minute measurements over a 24 hour period.
To configure the Auto Repeat function, enter the menu and select the Measurement
Duration option and then select the Auto Repeat option.
Key Press Display
Use the up and down arrows to change the number of measurements required and the left and right arrows
to move between the digits. Press OK to accept the changes or Exit to discard any changes made.
To Next Page
Loading...
Need help?
General
