Cisco MERAKI MR46 User Manual

MR46 Installation Guide
The Cisco Meraki MR46 is dual-band enterprise-class 802.11ax cloud-managed access points. Designed for the highest capacity and highest
density, MR46 meets the needs of the most demanding environments. The access point also includes a third radio dedicated to optimizing the RF environment
and securing the airwaves.
About this Guide
This guide provides instructions on how to install and configure your MR46 access points. This guide also provides mounting instructions and limited
troubleshooting procedures. For more wireless installation guides, refer to the wireless installation guides section on our documentation website.
Product Overview
Physical Specifications
MR46
Interfaces
• 1x 100/1000/2.5G BASE-T Ethernet (RJ45)
• 1x DC power connector (5.5 mm x 2.5 mm, center positive)
Power
• Power over Ethernet: 42.5 - 57 V (802.3at compliant)
• Alternative: 12 V DC input
• Power consumption: 30W max (802.3at)
• Power over Ethernet injector and DC adapter sold separately
Environment
• Operating temperature: 32 °F to 104 °F (0 °C to 40 °C)
• Storage and Transportation Temperature: -4 °F to 158 °F (-20 °C to 70 °C)
• Humidity: 5 to 95% non-condensing
Physical Security
Note: Actual power consumption may vary depending on the AP usage.
1

Cisco MERAKI MR46 Specifications

General

Wi-Fi Standard	Wi-Fi 6 (802.11ax)
Frequency Bands	2.4 GHz and 5 GHz
Power over Ethernet (PoE)	802.3at
Maximum Data Rate	3.5 Gbps
Environment	Indoor
USB Port	1 x USB 2.0
Antenna Gain	5 GHz: 5 dBi, 2.4 GHz: 4 dBi
Mounting	Wall, Ceiling
Operating Temperature	0°C to 40°C (32°F to 104°F)
Security	WPA3
Cloud Management	Yes
MIMO	4x4
Weight	1 kg

Summary

Security Features

Power Source Options

Factory Reset Button

LED Indicators and Run Dark Mode

Safety and Warnings

Pre-install Preparation

Configure your Dashboard Network

Guides on adding and configuring the AP within the Meraki Dashboard network.

Check and Set Firmware

Recommends ensuring the AP has the latest firmware before installation.

Installation Instructions

Choose Your Mounting Location

Provides guidance on selecting an optimal location for the access point.

Install the AP

Explains the general two-step process for mounting the access point using the cradle.

Attach the Mount Cradle

Details how to attach the mount cradle for various installation scenarios.

Getting Power to the AP

Explains how to connect power to the AP, especially for junction box mounts.

Attach the MR46 AP to the Mount Cradle

Details the process of physically attaching the MR46 AP to the pre-installed mount cradle.

Verify Device Functionality and Test Network Coverage

Check LEDs

Verify access point connectivity

Basic Troubleshooting

Reset the access point

Check Radio Functionality by Making the AP a Repeater

Check Ethernet Port Functionality by Connecting to the AP

Check Static IP Address Configuration