Cisco MERAKI MV12 - User Manual

Resetting Cisco Meraki Devices to Factory Defaults
Cisco Meraki devices can be reset to factory defaults using the reset button on the device. This requires a paper clip or object with a long thin tip. Insert the tip of
the paper clip into the reset button, press, and hold for 10-15 seconds, or until the power light goes out, which ever occurs first. This will reset the device to
factory defaults and reboot. If a static IP address was configured for the device, it will need to be configured again using the local status page.
Rack-Mounted Security Appliance
To reset a rack-mounted appliance security appliance to the factory defaults, press the button labeled 'Reset' on the front panel of the appliance for 10-15
seconds. This will clear the static IP address settings, DHCP lease pool, and local configuration of the device. Please be aware that after resetting the unit, the
device will need to download its latest configuration from Dashboard. Please be patient as this could take up to 5 - 10 minutes.
To reconfigure a static IP address on an MX Security Appliance, please follow the instructions on the following link: Static IP address on an MX Appliance
Compact MX Security Appliance and Z-Series Teleworker Gateway
To reset a compact (non-rack-mounted) MX Security Appliance or Z-Series Teleworker Gateway to the factory defaults, press the button labeled 'Reset' on the
back panel of the appliance for 10-15 seconds. This will clear the static IP address settings, DHCP lease pool, and local configuration of the device. Please be
Resetting a Meraki appliance to factory defaults will clear the local configuration stored on that appliance. This will clear any statically assigned IP
address information, Ethernet configuration, DHCP lease pool, and web proxy settings.
If a device is still in a network after being factory reset, it will redownload its previous configuration when it comes back online. If the configuration
needs to be completely reset, make sure to remove the device from its network before resetting to factory defaults.
1

Summary

Resetting Cisco Meraki Devices to Factory Defaults

Rack-Mounted Security Appliance Reset

Instructions for resetting rack-mounted security appliances via the front panel reset button.

Compact MX Security Appliance and Z-Series Teleworker Gateway Reset

Instructions for resetting compact MX/Z-series gateways via the back panel reset button.

MS Access Switches Reset Procedure

MS350 Series Switch Reset

Procedure for resetting MS350 series switches, located on the back of the unit.

Outdoor Access Points Reset Procedure

MR6 X and MR7 X Reset

Resetting MR6X/MR7X outdoor APs using the button below the Ethernet port.

Indoor Access Points Reset Procedure

MR1 X;2 X;3 X Series Reset

Resetting MR1X/2X/3X indoor APs; button location varies by model.

MV Security Cameras Reset Procedure

MV Camera Reset Locations

Details on finding and using the reset button for various MV camera models.

Cisco MERAKI MV12 Specifications

General

Video Compression	H.264
Frame Rate	30 fps
Power	PoE (802.3af)
Mounting	Ceiling or Wall
Camera Type	Dome
Resolution	1920 x 1080
Night Vision	Yes
Wireless	802.11ac
Ethernet	10/100/1000 Mbps
Humidity	Up to 95% relative humidity, non-condensing
Network Interface	1 x 10/100/1000 Ethernet
Audio	Built-in microphone
Cloud Management	Meraki Dashboard
Operating Temperature	-20°C to 50°C