Cisco - Hardware Troubleshooting for Cisco 12000 Series Internet Router Line Card Failures
http://kbase/paws/servlet/ViewFile/15926/hwts_gsrlc_15926.xml?convertPaths=1[8/6/2010 3:56:13 PM]
Slot 12: 0 crashes
Slot 13: 0 crashes
Slot 14: 0 crashes
Slot 15: 0 crashes
Router#show logging
Syslog logging: enabled (2 messages dropped, 0 messages rate-limited, 0 flushes,
0 overruns)
Console logging: level debugging, 24112 messages logged
Monitor logging: level debugging, 0 messages logged
Buffer logging: level debugging, 24411 messages logged
Logging Exception size (4096 bytes)
Trap logging: level informational, 24452 message lines logged
5d16h: %LCINFO-3-CRASH: Line card in slot 1 crashed
5d16h: %GRP-4-RSTSLOT: Resetting the card in the slot: 1,Event: 38
5d16h: %IPCGRP-3-CMDOP: IPC command 3
5d16h: %CLNS-5-ADJCHANGE: ISIS: Adjacency to malachim2 (GigabitEthernet1/0) Up,
n8 (slot1/0): linecard is disabled
-Traceback=602ABCA8 602AD8B8 602B350C 602B3998 6034312C 60342290 601A2BC4 601A2BB0
5d16h: %LINK-5-CHANGED: Interface GigabitEthernet1/0, changed state to
administratively down
5d16h: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0,
changed state to down
5d16h: %GRP-3-CARVE_INFO: Setting mtu above 8192 may reduce available buffers
on Slot: 1.
SLOT 1:00:00:09: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tmew adjacency) GS Software (GLC1-LC-M), Version 12.0(17)ST3,
EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Thu 08-Nov-01 20:21 by dchih
5d16h: %GRPGE-6-AUTONEG_STATE: Interface GigabitEthernet1/0: Link OK -
autonegotiation complete
5d16h: %LINK-3-UPDOWN: Interface GigabitEthernet1/0, changed state to up
5d16h: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0,
changed state to up
Router#show diag 1
SLOT 1 (RP/LC 1 ): 3 Port Gigabit Ethernet
MAIN: type 68, 800-6376-01 rev E0 dev 0
To Next Page
Loading...
Need help?
General
