Cisco - Hardware Troubleshooting for Cisco 12000 Series Internet Router Line Card Failures
http://kbase/paws/servlet/ViewFile/15926/hwts_gsrlc_15926.xml?convertPaths=1[8/6/2010 3:56:13 PM]
HW config: 0x00 SW key: 00-00-00
PCA: 73-4775-02 rev E0 ver 2
HW version 2.0 S/N CAB0450G8FX
MBUS: Embedded Agent
Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00
DIAG: Test count: 0x00000001 Test results: 0x00000000
FRU: Linecard/Module: 3GE-GBIC-SC=
Route Memory: MEM-GRP/LC-64=
Packet Memory: MEM-LC1-PKT-256=
L3 Engine: 2 - Backbone OC48 (2.5 Gbps)
MBUS Agent Software version 01.46 (RAM) (ROM version is 02.10)
Using CAN Bus A
ROM Monitor version 10.06
Fabric Downloader version used 05.01 (ROM version is 05.01)
Primary clock is CSC 0 Board is analyzed
Board State is Line Card Enabled (IOS RUN )
Insertion time: 00:00:10 (5d16h ago)
DRAM size: 67108864 bytes
FrFab SDRAM size: 134217728 bytes, SDRAM pagesize: 8192 bytes
ToFab SDRAM size: 134217728 bytes, SDRAM pagesize: 8192 bytes
1 crash since restart
Router#show context slot 1
CRASH INFO: Slot 1, Index 1, Crash at 10:36:20 UTC Wed DEC 19 2001
VERSION:
GS Software (GLC1-LC-M), Version 12.0(17)ST3,
EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Compiled Thu 08-Nov-01 20:21 by dchih
Card Type: 3 Port Gigabit Ethernet, S/N
System exception: sig=10, code=0x10, context=0x41036514
System restarted by a Bus Error exception
STACK TRACE:
-Traceback= 406914C8 4004EEAC 4005BCE4 400A33F4 400A33E0
CONTEXT:
$0 : 00000000, AT : 41030000, v0 : 00000000, v1 : 41036290
a0 : 00000030, a1 : 412C6CA0, a2 : 00000000, a3 : 00000000
t0 : 00008100, t1 : 34008101, t2 : 400C5590, t3 : FFFF00FF
t4 : 400C5560, t5 : 00040000, t6 : 00000000, t7 : 413D1D78
s0 : FF012345, s1 : 00000031, s2 : 41032B10, s3 : 41BB8F00
s4 : 00000000, s5 : 00000001, s6 : 4101D620, s7 : 00000000
t8 : 418EA1C8, t9 : 00000000, k0 : 4142C7A0, k1 : 400C7538
To Next Page
Loading...
Need help?
General
